• Reviews around sensor (1.95 of 5)

    ANCEL AD310 Classic Enhanced Universal OBD II Scanner Car Engine Fault Code Reader CAN Diagnostic Scan Tool - Black

    • Replaced the sensor, cleared the code, and I was good to go
    • What it can do or show in live data depends on available sensors and computer output from the vehicle
    • We found out that it was a dirty Mass Air Flow Sensor, and was fixed with a $10 can of MAF Sensor Cleaner
    • Plus gets rid of the pesky check engine light I get when one sensor gets to cold.
    • The live data stream helped me diagnose a failing catalytic converter on one car and a bad sensor on another.
    • but it told me both bank one and two number one sensors where bad .works fine on my 2007 Nissan pickup and 2014 Chevrolet camaro but does not work on my 2010 Malibu
    • He looked up the code and found another thing that would cause it is a dirty sensor, which can happen if your air filter is mucked up
    • I replaced bad sensors this tool found and also reset the codes
    • Works great, Easy to use, Would not reset all my engine codes, but I believe that may be because of a faulty sensor on my truck
    • Also helped me identify a faulty O2 sensor that caused a misfire.
    • Everyone should have one located my problem in no time bad crank sensor and float switch on fuel pump no more Check Engine light
    • that has the light check engine on due to an faulty sensor; Two or three times I tried to remove that light and works while I do not turn off the car; when I turn it on the car, the check engine lights on again
    • It worked perfectly, after I replaced the faulty sensor , l plugged it back in and erased the code, the check engine light turned off.
    • Most cases in the past an engine light would mean bad o2 sensor
    • right away it gave me 4 codes and they were all related to my missing 4 o2 sensors
    • This truck has been running with a check engine light on for over a year, I've pulled the codes before, which were P0446 (EVAP System Vent Control Circuit); P0441 (EVAP System incorrect Purge Flow); P0136 (O2 Sensor Circuit Bank 1 Sensor 2) and P0156 (O2 Sensor Circuit Bank 2 Sensor 2) just a month ago.
    • Cleaned the sensor and cleared the fault
    • With this tool, I was able to detect that the sensors were ready the next 2
    • Is your car going to explode if you don't replace the knock sensor or O2 sensor
    • Hooked it up to my 07 Hyundai Santa Fe that did have codes and light on and it pulled up exactly what was wrong, I corrected the issue/s and used this unit to reset all codes, worked like a champ
    • Hooked it up to my 07 Hyundai Santa Fe that did have codes and light on and it pulled up exactly what was wrong, I corrected the issue/s and used this unit to reset all codes, worked like a champ