-
I found they were pretty easy to put together, as other reviewers recommended, it makes it a lot easier to assemble if you leave the screws loose and then tighten them all once they are all in; otherwise you risk holes not lining up (there are only 12 screws), 4 for the seat and 4 for each armrest, pretty easy
-
Not easy to put together, in fact the screws are not long enough to put into the top of the chair
-
The last two screws gave me a hell of a time, but it was worth it.
-
We found that the seat had a crooked screw receptor for one of the armrests so that it could not be attached
-
The back support only uses two screws, so the it wobbles back and forth when you stand and sit
-
Cannot get both screws in on either side very disappointed
-
the the two screw holes that held the arm rests to the back of the chair were obviously set to a position that would not allow proper screw installion
-
Product arrived with misaligned screw hole in the side of the back rest and the screw hole in the arm of the chair
-
The hex key solid, the screws are TIGHT once seated.
-
The screws consistenly fall out, and if you lose the little screw driver that comes with it good luck trying to get the screws back in-i lost the little screw
-
And unfortunately, that screw is extremely important for the structural stability of the chair
-
One can feel the hard base and the screws while sitting on it
-
As some others have mentioned, the screws can be a little tricky to get in, but I didn't have much of an issue
-
The back support only uses two screws, so the it wobbles back and forth when you stand and sit
-
A few screws worked themselves loose and a few screw covers did the same, but over all great
-
A few screws worked themselves loose and a few screw covers did the same, but over all great
-
The chair is okay, the screws for the back of chair are very hard to get in and they keep falling out.
-
The screws for the arms are constantly working
-
It seems to have sunk a good inch or two from when I first got itThe screws come loose often, every month or so I make sure to re tighten them because I had one basically fall out at one point
-
It felt like something was digging into the middle of my back, something hard but not a screw
-
The screws that hold the back of the chair up are very hard to get installed.
-
The screws did not work for the back of the chair
-
only problem I had was the last screw did not totally go in
-
Now if you put too much weight on the left armrest, the screw pops out and you can't lean back anymore
-
the good, chair looks really nice fro first eye, unfortunately after a year of using it, parts started to fall apart, screws, got squeaky, the seat ripped from sitting on it