Spend the extra money and get something better rubber casing on the outside of the power wires what makes up the gauge not the copper itself the center tip on the RCA cable broke off and fuse block is cheap plastic broke when screwing it in by hand to the finder

The in-line fuse is the cheapest part, the plastic is brittle and the fuse itself is glued onto its housing

had to use what was left over from the power cable to reach good ground and the plastic

The RCA cable that came with this setup one end is a nice sturdy robust metal the other end is this soft flimsy plastic

Plastic falls off during the crimp.

I found it easier and more secure to slip those on versus the hard plastics

The RCA cable that came with this setup one end is a nice sturdy robust metal the other end is this soft flimsy plastic

If the seller actually reads these my only recommendation would be to get rid of the red hard plastic around the ring terminals and go with just the red rubber pieces only

I can see why people say it’s cheap plastic but nonetheless, it works perfectly!!

The fused holder has very apparent damage from overheating and is made of cheap, brittle plastic

The fuse holder is made of cheap plastic, broke before I even had a chance to install it

Worked as it should.

All the lengths are plentiful and everything works as it should

n’t burn down