Ernie Ball VP Jr. P06180 250K Potentiometer for Passive Elec... - 2024 report by Whydis
Ernie Ball VP Jr. P06180 250K Potentiometer for Passive Electronics
Size:250k
Product Description
The potentiometer has a 250k ohm resistance suitable for the audio path of passive instruments. Behind the jack area under the footplate is a micro taper switch which provides the user two distinct volume swell rates. ...
Has worked perfectly with my EMG active pickups without any problems & with passive pickups as well.
I soldered a 4.02kohm across the end connections of the pot (any value near it would work as well), but that only shifts the complete pedal movement to change the volume to go from half to full volume
You are reading snippets from reviews of Ernie Ball VP Jr. P06180 250K Potentiometer for Passive Electronics
The pedal works well enough if you are using a passive instrument and the pedal output is plugged into a high impedance input (most pedals are low impedance)
25K "low impedance" is ideal for FX loop.
You are reading snippets from reviews of Ernie Ball VP Jr. P06180 250K Potentiometer for Passive Electronics
.... Seeings how I need smooth swells in songs we do & I use this pedal for volume boost for leads as well, I can honestly say .....
This pedal,to me, feels effective,responsive & goes from zero and gradually increases thruout the range of the pedal, which allows me to make nice swells in our songs
You are reading snippets from reviews of Ernie Ball VP Jr. P06180 250K Potentiometer for Passive Electronics
And unlike other volume pedals, replacement "pots" are readily available, so when it eventually wears out and the pot gets "scratchy" I can repair it myself instead of buying a new one.
You are reading snippets from reviews of Ernie Ball VP Jr. P06180 250K Potentiometer for Passive Electronics
I soldered a 4.02kohm across the end connections of the pot (any value near it would work as well), but that only shifts the complete pedal movement to change the volume to go from half to full volume
You are reading snippets from reviews of Ernie Ball VP Jr. P06180 250K Potentiometer for Passive Electronics
I soldered a 4.02kohm across the end connections of the pot (any value near it would work as well), but that only shifts the complete pedal movement to change the volume to go from half to full volume
You are reading snippets from reviews of Ernie Ball VP Jr. P06180 250K Potentiometer for Passive Electronics
The main pivot shaft is of centerless ground 1/2' diameter stainless steel, precision seated though nylon bushings at both ends
The large center shaft diameter, in addition the strength factor, creates a broader stress bearing surface
Our bodies and shafts are designed to give the player an indefinite service life! Deck mat of non-slip material is impervious to oil, alcohol, and most things you might spill on it
Quick disconnect wiring harness allows changing the pot without soldering
Tough long lasting Kevlar cable transmits pedal travel to the controls and is attached by stainless steel springs
This drive design results in smooth and quiet operation qualities lacking in gear driven models
Cycle tests are made on every pedal to insure perfect operation prior to packaging.
Save on
Pinterest