-
Very simple to install I did burn out one connection point my fault not the manufacturers
-
I was forced to remove all the connectors and use wire/solder for a reliable connection(s).-The PCB on these LEDs is extremely thin/light...use caution when soldering.... its easy to completely burn through the copper/PCB when soldering, which forces you to cut the strip to the next set of connections and try again
-
With enough power connections along the strip, the 72 Watts can probably be achieved
-
Two, the connection clips included are junk and don't hold a solid connection
-
I've had to cut off strips to find a good, working connection with some.
-
If you use connectors rather than soldered joints, I suggest using hot melt glue to further secure the connection and protect it from oxidation
-
Recommend soldering connections as the clamp connectors don't seem too robust
-
Not as warm as I was lead to believe