-
The weight of the phone pulls my vent slats
-
Overall, I'm sure this works great for horizontal vent slats, just didn't work out for me.
-
I have a ‘06 Scion xB and the vent slats are doubled making the area to clip to about 3x the width of regular vents
-
Attach a small square of velcrow to one of the vent slats, and the other to one of the clamps on the unit.
-
Works perfectly in my wifes cars with horizontal vent slats, but not so much in the vertical slats of my truck
-
The vent in our Dodge Ram has vertical slats in the back of the vent.
-
Works exactly as it should and has no problem holding my phone (although one corner slightly rests against the radio wall).
-
Find that because the clamp does not close parallel but closes on an angle I was limited as to where I could install it so that it wouldn't slip
-
It's a LOT smaller than the original mount too which I like as it makes room for other things in my case.
-
A little disappointed with this as with
-
Purchased twice, shame on me, both broke as it was being tightened.
-
Holds phone securely and allows the A/C vent to work as it should.
-
This usually doesn't occur with WizGear products, so im genuinely confused as to why it simply fell apart
-
Worked exactly as I had hoped.