I used the chair daily as an office chair so not terrible value but had hoped the chair would've lasted longer and shocked to see the metal piece break in half but out to the curb it goes!
Overall a pretty good value for the $ (assuming it lasts a few years), but not an outstanding chair.
A little difficult to assemble because the parts aren't able to lay flat as you assemble them so it'd be best done by 2 people
This chair is awesome, it is supportive and comfortable, excellent value for the price
Chairs work well, are comfortable, and are a good value buy.
I keep the tilt/recline lever pulled out so that my chair doesn't make any clicking noises as I rock throughout the day, and this has no negative impact on my posture or ability to sit up
Good price, reasonably comfortable, but very loud and not well-constructed.
Great price and a comfortable chair that you can sit in for some time.
There is clicky issues despite me assembling the chair as tightly as I
Good price, reasonably comfortable, but very loud and not well-constructed.
This chair is a solid product and was easy to assemble with just the included tools.
Great product for such a low-priced chair, as long as you aren't expecting an Aeron
The right arm rest is lower than the left one, I thought it was some loose screw, so tightened everything again and it still tilts, so I will NOT recommend this product
I followed the instructions during set up and don't believe the product is defective, just poorly designed
the product i received was defective, the fixture holes to connect the base and back piece isn't at the correct distance
I found the back to be fairly supportive and the seat cushion very nice, aside from the scratchy mesh
The mesh on the back came damaged but Amazon took care of it without problem
The mesh on the armrests is super uncomfortable if you're bare armed.
The back mesh is not bad to lean against, but really I've had a blanked over the back and the seat the whole time so its more about the support (which is, again, ok).
It's very comfortable to sit in for hours, and the mesh backing keeps your back cool in the summer time
There is clicky issues despite me assembling the chair as tightly as I
A little difficult to assemble because the parts aren't able to lay flat as you assemble them so it'd be best done by 2 people
I keep the tilt/recline lever pulled out so that my chair doesn't make any clicking noises as I rock throughout the day, and this has no negative impact on my posture or ability to sit up
I use this chair for productivity as well as for gaming.
A little difficult to assemble because the parts aren't able to lay flat as you assemble them so it'd be best done by 2 people
Bolts that come with it seem to be made of the weakest/cheapest possible metal
What have I leaned from all the chairs I have bought for computers the past 6 years?It is best to spend as much money as you can afford otherwise you will most likely have a chair that is either crap , bad back support, falls apart and wont last long
A little difficult to assemble because the parts aren't able to lay flat as you assemble them so it'd be best done by 2 people
The mesh seat likes to pick up crumbs and stuff and is hard to clean off as they get stuck in it.
Chair feels as good as those costing twice as much in some stores
The mesh seat likes to pick up crumbs and stuff and is hard to clean off as they get stuck in it.
Decent chair, but after 3-4 months the threads are damaged for the flip arms
You crank down on these and you will strip out the threads or break the nut loose
A little difficult to assemble because the parts aren't able to lay flat as you assemble them so it'd be best done by 2 people
What have I leaned from all the chairs I have bought for computers the past 6 years?It is best to spend as much money as you can afford otherwise you will most likely have a chair that is either crap , bad back support, falls apart and wont last long
The fabric is very abrasive, and it has an almost overpowering chemical smell
the fabric is fine - i have had tiny bits of paper get stuck in the mesh of the seat, and the shape of the back is a little uncomfortable for me, but i use that as a reminder to sit up straight
the only complain is the fabric is a little rough, besides that it's amazing.
The fabric is durable and is holding up well so far, but it is also "scratchy" I don't like setting bare skin on it, and it has little pits that easily collect dirt and dust
But the fabric is quite rough, almost abrasive, and may irritate your skin on your forearms or if you wear shorts or skirts
What have I leaned from all the chairs I have bought for computers the past 6 years?It is best to spend as much money as you can afford otherwise you will most likely have a chair that is either crap , bad back support, falls apart and wont last long
the initial weak tilt mechanism is why I dropped a star from the rating
I use this chair for productivity as well as for gaming.
the mechanism that keeps the back 'up' (not rocking) seems to have broken, and the hydraulic piston loses pressure slowly.
The mesh seat likes to pick up crumbs and stuff and is hard to clean off as they get stuck in it.
The mesh in the back has stretched and the hard plastic support digs into my back and neck.
It's a decent chair, but when you sit up and press your back to the back of the seat, the hard plastic on the top rim of the chair's backing pushes painfully against the back
I tend to sit into the back of the chair and lean back at my desk and the hard plastic after a few minutes becomes a pain and is not comfortable for me.
Chair feels as good as those costing twice as much in some stores
I definitely would not recommend assembling this using the included Allen wrench, I used a battery powered drill with a driver bit that fit inside the included screws, and I had no issues during assembly apart from needing to disassemble and reassemble one of the pieces because I didn't notice that I was supposed to use some included washers underneath the screws to protect the plastic
Its a good chair thus far, my ONLY complaint is that when I shake my leg, the chair makes noise
I keep the tilt/recline lever pulled out so that my chair doesn't make any clicking noises as I rock throughout the day, and this has no negative impact on my posture or ability to sit up
When I first started using the chair, at first I did not think it would rock, only moving slightly and making a horrible noise.
Unfortunately, there's also creaking noises only a few days after use.. if you want your back to hurt a bit more, be sure to get this chair
There is clicky issues despite me assembling the chair as tightly as I
Like another user , my chair developed the side tilt and eventually the plate cracked and broke
Only giving a 3 star because the chair can't tilt to the back despite the description says that it has a "Tilt Lock Mechanism with Tilt Tension Knob" from which I assume that means the chair can tilt to the back
Chair is very comfortable, it rolls around easy, and it has very smooth tilt retention
Now, you can flip them out of the way ... and not have them at your side ... but they are not adjustable.- concerning the "adjustable tilt" - I would not call this an "adjustable tilt" at all.
It creates an anterior pelvic tilt, very bad for your back and can't sit in it longer than 10min
hard wood floors and did't want a pad hence the urethane casters which literally make the chair seem like it is floating silently across the floor and do no damage to the floor.
Be careful especially on the seat where the screws can easily strip the nut out or crack the wood
Ply wood is weak and the screw holes fatigue inside the wood over time with the cheaper type from wal mart
The bolts that attach the back to the seat pulled straight through the wood breaking, cracking, and splitting the wood bottom making the back unable to rebolt to the seat
The wood that makes up the base of the seat is so weak that it's been splintering and cracking, and if I lean back it feels like the back is going to crack right off and separate from the seat
There is clicky issues despite me assembling the chair as tightly as I
I keep the tilt/recline lever pulled out so that my chair doesn't make any clicking noises as I rock throughout the day, and this has no negative impact on my posture or ability to sit up
I keep the tilt/recline lever pulled out so that my chair doesn't make any clicking noises as I rock throughout the day, and this has no negative impact on my posture or ability to sit up
There is clicky issues despite me assembling the chair as tightly as I
There is clicky issues despite me assembling the chair as tightly as I
You are reading snippets from reviews of Mid-Back Black Mesh Swivel Task Chair with Mesh Padded Seat and Flip-Up Arms
More about Mid-Back Black Mesh Swivel Task Chair with Mesh Padded Seat and Flip-Up Arms
Color:Black Mesh
|
Style:Mid Back
This mesh task chair provides exceptional support to the hard-working professionals in your office.Transparent mesh across the back allows air to circulate, keeping you cool no matter how high the pressure gets
Built-in lumbar support helps prevent back strain and muscle fatigue
The swivel seat is padded with three-inches of CA117 fire retardant foam and covered with black mesh upholstery
Its waterfall edge is designed to relieve pressure and promote healthy blood flow to your legs
Raise and lower the seat using the pneumatic seat height adjustment lever, conveniently located under the seat
Turn the tilt tension adjustment knob to increase or decrease the amount of force needed to rock or recline
Lock the seat in place with the tilt lock mechanism
Padded armrests take pressure off your shoulders and neck, and flip up and out of the way, as needed
The heavy-duty, nylon base with dual wheel casters makes it easy to roll across the floor.Whether it's a day filled with meetings or you're working to beat a tight deadline, this stylish chair will keep you cool and comfortable throughout your busy day.