Bolts that come with it seem to be made of the weakest/cheapest possible metal

'15 and in May '19 the metal that holds the chair in place broke in half while sitting in the chair

The included allen wrench is made out of a similarly cheap metal to the screws, as the wrench was destroyed before I could finish assembling the chair

nearly fell over backwards because the metal(?) plate that attaches to the seat partially ripped, and I only weigh 165 pounds. if you decide to lean back on this chair make sure you have a soft landing place.

I use this chair for productivity as well as for gaming.

A little difficult to assemble because the parts aren't able to lay flat as you assemble them so it'd be best done by 2 people

What have I leaned from all the chairs I have bought for computers the past 6 years?It is best to spend as much money as you can afford otherwise you will most likely have a chair that is either crap , bad back support, falls apart and wont last long

Chair feels as good as those costing twice as much in some stores

The mesh seat likes to pick up crumbs and stuff and is hard to clean off as they get stuck in it.