then I'd try to pull the phone off the magnet to use and it would rip the ball off the dashboard with it

Now, the ball comes off the console and my phone falls all the time

I was really excited to use this cool Steelie ball

The magnetic ball is not secured into the mount, so it cannot be used in my car.

However, my issue is design...while the other balls give you 2/3rds the ball to work with and thus allow a lot of variation of tilt etc the pedestal only gives you half the ball (maybe to limit tipping).

I also have the cheaper ball and cup system and have been very pleased with this as well

Why would you have a rotating ball in this application, dumb.

This works awesome IF you take some emery paper and scuff up the steel ball that mounts to your dash or whatever.

The balls is strong but as soon as you hit a bump your phone falls and

So the magnetic ball that sticks on the surface fell off 4 times

I wish I could return it because the magnet came off my phone and now all I have is a useless ball on my car vent

I gave three stars only because the coating on the magnet wore off in a week and the cheaper no choice ball magnet my coworker bought has held up much better

My cheaper magnetic ball mount did a great job but double sided tape failed so I decided to spend a bit more and get my money worth

Originally purchased vent ball mount with magnetic ball socket

I had to super glow the ball on my camaro leather dashboard and also the magnet on the phone is annoying and might hurt your phone

I had to super glow the ball on my camaro leather dashboard and also the magnet on the phone is annoying and might hurt your phone

You can put the ball back on and as it cools it sticks itself back in

The ball fell right out of the base

The stylish silver ball does not look crazy when phone not attached

I wish the ball was rougher of the grip was stronger

TIP" clean the ball and the red rubber area at the base of the magnet with alcohol every once and a while

Interestingly, the small, shiny steel 1" diameter ball and mount, with my iPhone removed, has a simple, attractive elegance that makes all the claw-like/vise-grip phone and tablet car mounts look gross and obtrusive

And the ball on my dashboard has surface rust

However the ball was hard to use with thicker fingers

Truck rides rough so the vent clip ball and magnet doesn't hold phone very still

I tried to roughen the ball with 100 grit sandpaper at first but ended up using a stone bit on a drill to texture the ball surface enough to stabilize the phone’s weight

Vent ball mount was heavy that would tilt the vent down and the phone as well most of the time

Nite Ize Steelies are hands down the best magnet/steel ball combo

Furthermore, I followed the instructions on placing the magnetic ball mount on my dash; cleaning and wiping with the alcohol wipes and waiting for the sticky pads to get a firm grip before trying, only to yet again find that the sticky pads aren't strong enough to combat the magnets' pull

I tried cleaning the steel ball and the rubbery piece in the socket, but it couldn't be restored.

When it gets hot the ball falls off your dashboard

Guess I'm the only one out $23.Anyone need a glorified ball-barring?!?

The smooth ball has nothing to bite into to keep hold.

Went driving down the road and the round magnetic ball would let the phone roll as you went around curves, then eventually then the phone sink to where it was angled too far down

The double sided tape in the ball is cheap, ball keeps falling

it’s not sticky enough and my phone falls bringing the ball with it

The remedy it so use a tissue and some rubbing alcohol to clean both the gasket and also the steel ball.

Once I scuffed up the steel ball the thing works awesome.

Day 2: The ball fell off my dash, and disappeared

but the ball fell off the first time

I followed the installation directions ( twice and even ordered another installation kit) and the ball continued to fall off

and now that I’m missing a

Once I did this everything works as

The only thing I would add is a little rubber pad on the part that touches the back of the phone but it still works as it should with the way it is

We’ve tested both and mine doesn’t magnetize the things nearly as well as his