-
It's a good amount of work to get it right, and it's mostly just sanding down the bad spots on your headlights, but the final application is what makes it flawless
-
It states if you miss a spot, go over it lightly again
-
n’t go over it fast enough if you missed a spot before it dries
-
but I missed a spot
-
Did the job of getting the bad spots on the headlight plexaglass.
-
One thing to be mindful of, if you miss a spot while applying the UV coating immediately go over the missed area
-
Don't try to fix any missed spots if it's been more than a few seconds, because it will be drying, and the new stroke will probably make a sticky mess
-
Final step of wiping on the urethane clear coat was a bit tense, as of you miss a spot or don't get it quite as you like in the first wipe, you better get it right within 30 seconds or so, because the stuff sets up fast
-
but I'm certain it is because I didn't sand it long enough in one of the steps (there is a missed spot)
-
Trying to go back and touch up a missed spot in the UV coating after there's already a coat applied is like trying to fix halfway dried nail polish
-
it made a couple rough spots almost like sand paper
-
t trick befor and nothing changed.
-
n’t go over it fast enough if you missed a spot before it dries
-
We were sure it was going to work, but holy sh*t did this kit work
-
n’t know about longevity yet but would recommend for any headlight because of the 400 grit sand paper that really has ales care of any strong corrosion
-
Just do t get ‘freaked out’ at the way the lenses look until you apply the UV coating
-
We bought an older car for our daughter to drive, unfortunately the headlights at night were t the best
-
n’t look cloudy anymore