(I chose to keep a bubble free, if slightly off center)

But the bubbles really are very minor and don't interfere with the viewing area of the screen and are, in fact, behind the edge of the new cover I've bought for the Fire HD.

There's no question there's an art to installing a screen protector without leaving a lot of unsightly and annoying air bubbles.

Good thing they give you three of them because that's how many tries it took me to get a bubble free application.

By doing it this way, we only had a couple really small areas to work out air bubbles.

Take your time while laying down the protector and slowly work the bubbles out as you go

The directions are well spelled out, all the tools required are right there in your package, and I had no trouble getting the few bubbles out.

It did not come with that piece to smooth out the bubbles but you can use your drivers license or any card for that.

, I applied it slow and smoothed out all bubbles and only one tiny speck of dust, which was my own fault because I pulled up the peeling layer too much and didn't realize

The screen protector was easy to apply, and relatively easy to work out any air bubbles.

Keeping the top part of the backing on, I used an old credit card to smooth out the air bubbles (the card provided is small).

smooth out the bubbles with the included piece3

The hardest part is getting out the air bubbles, but again they have included a little applicator that looks like a small credit card, to smooth out those pesky bubbles

The bubbles smother out like the instructions said they should.

Like others, there are also bubbles under the protector, but the biggest problem is this tab that is in the corner

, miniscule dust speck were attracted to the sticky side of the screen and impossible to remove - causing bubbles to arise that could not be worked out.

Work the bubbles out as you apply the

Be careful to start at the camera and work your way out to the center all the way up the middle, working out all the bubbles as you go with the "tool" they gave you.

You either get finger prints on the sheet or the plastic doesn't smooth out air bubbles from underneath

I was not satisfied with the application though, bubbles were somewhat hard to get out

Don't try to lay the whole screen protector down and try to work out the bubbles after.

I thought perhaps the bubbles ... about 5 small ones after all was said and done, would not be a huge problem.

It went on quite easily and it was easy to smooth out the bubbles.

, I quickly applied it and had less bubbles and was satisfied with it.

I tried twice with two different screen protectors and could not get a bubble free installation.

Follow instructions on film placement, use included card to smooth out bubbles WHILE installing and pull back to redo it if needed

They did provide a tool to smooth out/push bubbles out.

It's easy to miss a bubble or two under the film and then you have to start over.

easy to put on, would definitely recommend this product to anyone, should have bought more, love it not even a bubble!

We also tried the Moshi brand screen protector which worked right the first time--no bubbles, dust, creases or waste.

I smoothed out the 6 tiny bubbles that were on it with the enclosed tool

I had to throw the first one away because even after meticulously cleaning my Kindle screen, a microscopic particle appeared from nowhere and created an irremovable, highly distracting bubble over the text

It even comes with a small plastic tool to smooth out the bubbles in the plastic

Happy with this - it's no hassle application, bubble free

I recommend it for everyone it is easy to put on and no air bubbles really good

Make sure you use the straight-edge that comes with it, or a credit card, to help smooth out the bubbles

After pulling off the back and smoothing out as many bubbles a possible I pulled off the front which caused even worse bubbles

These are hard to install if you care about the nasty little bubbles and pieces of dust beneath the protective sheet

After pulling off the back and smoothing out as many bubbles a possible I pulled off the front which caused even worse bubbles

Have to push hard on screen to work out the bubbles.

Happy with this - it's no hassle application, bubble free

It is almost perfect, just a small bubble in the black area.

were less trouble to put on than any of the others, and the few tiny bubbles that were there were soon gone using the tool provided.

The little rectangle device that is included to smooth out the air bubbles, left scratch marks all over the screen protector

I cleared all the bubbles, but it is a fraction of a centimeter off square and I plan to use another one to fix this.