It currently supports about 75 lbs. of gear

It is a tension adjustment of a screw against the inner leg, and if properly tightened should be adequate: if not, once you determine your preferred height(s), you could drill the inner leg and use a longer screw or pin.

My turntables are positioned on top of their road cases to reach a my desired height of about 40”.The criticism about the legs sliding is accurate, but is rectified by tightening the legs into the spring-peg hole

Probably there are sturdier table stands, but most of the others I have found cost significantly more, and have their lowest height a few inches higher

This table has been great!

This is not a strong stand to place any thing of value on it to sit

this is a very sturdy stand.

It is a tension adjustment of a screw against the inner leg, and if properly tightened should be adequate: if not, once you determine your preferred height(s), you could drill the inner leg and use a longer screw or pin.

Built solid, adjustment features work well.

It is a tension adjustment of a screw against the inner leg, and if properly tightened should be adequate: if not, once you determine your preferred height(s), you could drill the inner leg and use a longer screw or pin.

Built solid, adjustment features work well.

Not a good product for gigs

As this is a folding stand, there is some side-to-side sway, similar to any garden variety folding table

The advantage this stand offers over a standard folding table is collapsibility and portability

It is a tension adjustment of a screw against the inner leg, and if properly tightened should be adequate: if not, once you determine your preferred height(s), you could drill the inner leg and use a longer screw or pin.

This one is lower than many others at the shortest setting, so that is not a concern, although it may not be tall enough at the top end for some to play standing, as noted in other reviews

It is a tension adjustment of a screw against the inner leg, and if properly tightened should be adequate: if not, once you determine your preferred height(s), you could drill the inner leg and use a longer screw or pin.