-
Yes, I cleaned the surface and waited for them to set in place before testing them
-
It says to stick them on a clean surface, we did
-
Perhaps it's our fairly-mundane custom cabinetry but there isn't a straightforward flat surface on many of the cabinets to adhere to
-
Took about two minutes to clean the surface, as other reviewers suggested, line up and stick on
-
Make sure you clean the cabinet surface where you intend to place the sticker to ensure a good seal.
-
The installation is "easy" in that most cases don't requiring anything more than two clean adhesive surfaces, but getting everything to line up perfect in both the x and y directions is not straightforward
-
The adhesive sticker didn't hold on several of them long enough to drill (yes, I cleaned the surface per the instructions), and 2 of them didn't latch on at all after installation
-
every penny.*tip* I applied rubbing alcohol to clean the surface first before sticking them
-
They're easy to install, but please make sure to clean the surface first
-
Fell off in a couple of days with no one around -- and, yes, I cleaned surface before and applied correctly.
-
Would be to clean the surface as directed
-
This should be obvious: It is important to clean the mounting surface WELL or the glue will fill with dirt
-
Adhesive surface is great, no need for screwing these in.
-
If you pull slowly, it works as it should
-
It was a hit and miss as in some cabinets it would hold in others not so good.
-
They work as they should!