• Reviews around brick (3.33 of 5)

    Holiday Joy - 4 Metal Brick Clip Fastener Hooks - Holds Up to 25 Pounds - Fits Brick 2-1/8 inch to 2-1/2 inch in Height - Made in USA (4 Pack)

    • My bricks are old and misshapen and they worked everywhere
    • My brick was almost too small but it worked.
    • The clips do not grip the brick well and kept popping out.
    • These are by far the best brick hooks.
    • Easy to install and gripped the brick very well.
    • The hardest part was spending the time to find just the right locations with enough brick edge, close enough to where I wanted my art, in places where the other clip would also have enough brick edge to grip
    • Worked well where I could find consistent brick.
    • Maybe it’s my brick, but these didn’t work out for me at all.
    • I was torn because I didn't want to damage the bricks for
    • These clips are easy to use and wont harm the brick
    • Our fireplace in the den is in a whole wall of dark brick.
    • Painted brick, holes in brick, sandblasted brick, all horrible.
    • Did not fit my brick, strange because my brick is a normal acme brick
    • They are very easy to remove, and do not harm the brick or cement at all
    • We have really shallow and narrow bricks around our fireplace, and I was able to use these to hang some unframed canvas.
    • These did not fit my brick but still work for what I wanted to do.
    • Did not fit my brick, nor will it work without large groutless ridge
    • My brick is about 1/8th or 1/16th over what it 2.5 and it did not work.
    • I don't think there was enough exposed brick for the "teeth" to grab onto.
    • Alas, my brick wasn't "deep" enough so the clips could not latch on.
    • Our bricks were reclaimed so it was a challenge to find a nice flat edge that was wide enough and deep enough to really get good contact.
    • Worked as mentioned, our brick was slightly taller than the clip, but my fiancé bent the metal spring parts, a little bit, to get it to latch on... with a screwdriver
    • If you have wider bricks (2 1/2"), its best to bend the "springy" part down a bit to make it easier to snap on the the brick
    • Make sure you measure your brick to get the right size and make sure you have a clean brick edge.
    • Our home had beautiful clinker bricks which someone had painted, then someone else had sandblasted
    • Would have gave no star did not fit my brick very unhappy
    • I supposed theres not enough brick exposed from the grout
    • Once on the brick holds well and no drilling!
    • so I did not have to put a hole in my beautiful brick, just to hang some ornamental decorations