Monoprice Stage Right 10-Inch Powered Studio Multimedia Subw... - 2024 report by Whydis
Monoprice Stage Right 10-Inch Powered Studio Multimedia Subwoofer - (605999)
Every studio, be it a professional recording studio or just a home studio, needs a good set of monitor speakers, with a flat frequency response so you can hear exactly what the recording will sound like. If your mix needs a little more energy in the ...
It's well built, has all the controls I could want to sculpt the sound to my needs, and pushes clear, powerful audio that could blow the windows out of my house.
You are reading snippets from reviews of Monoprice Stage Right 10-Inch Powered Studio Multimedia Subwoofer - (605999)
If you don't have that, you won't get the right sound out of this sub
I don't actually have it configured for balanced passthrough, but I was able to get the right sound by running the LFE out on my Integra DTC-9.8 through an XLR
As a result, you get a rough air sound that goes "pfft"
You are reading snippets from reviews of Monoprice Stage Right 10-Inch Powered Studio Multimedia Subwoofer - (605999)
More about Monoprice Stage Right 10-Inch Powered Studio Multimedia Subwoofer - (605999)
Every studio, be it a professional recording studio or just a home studio, needs a good set of monitor speakers, with a flat frequency response so you can hear exactly what the recording will sound like
If your mix needs a little more energy in the bass, then you should get a 10-inch Powered Studio Subwoofer from Monoprice! This studio-quality subwoofer designed to be integrated with your studio monitors, for use with recording, mixing, and mastering duties
It features a built-in 200-watt (RMS) class AB amplifier
Designed for professional use, it features two balanced XLR and two ¼” balanced TRS/ unbalanced TS audio inputs and outputs
It boasts a 30 ~ 150 Hz frequency response with a signal-to-noise ratio greater than 90dB (A-weighted) and less than 0.03% total harmonic distortion at its rated power
It uses a 10" fiberglass composite cone and produces 110dB peak sound pressure level at 1m
It features a 1/4" TS input for use with a foot switch (not included)
The foot switch allows you to bypass the subwoofer and its crossover, allowing the original, full-range signal to be sent to the outputs
This allows you to compare your mixes with and without the subwoofer handling the lower frequencies
Performance: Amplifier Type: Class AB Frequency Response: 20 ~ 150 Hz Low Pass Filter Frequency: 50 ~ 150 Hz (Variable) S/N Ratio: >90dB (A-weighted) THD: <0.03% @ Rated Power Amplifier Power: 200 watts (RMS)/ 400 watts (Peak) Peak SPL at 1m: 110dB Woofer: 10" fiberglass composite cone Inputs: 2-XLR Balanced, 2-TRS Balanced/Unbalanced Outputs: 2-XLR Balanced, 2-TRS Balanced/Unbalanced User Controls: Input Gain Control: -30 to +6dB Polarity Switch: 0 or 180 degrees Bypass Footswitch: On/Off Mode Switch: Off/Auto/On Protection: Output-Current Limiting: Yes Over-Temperature: Yes Turn-on/off Transient: Yes Subsonic Filter: Yes