Whydis Logo
Computers & Accessories Tablets

  • Reviews around sink (4.47 of 5)
    ★★★★★
    ★★★★★

    Neiko 10174A Quick Change Spiral Grooved Step Drill Bit | 10 Step Drill Bit Sizes in One - 1/4" to 1-3/8" | High-Speed Steel and Titanium Nitride Coating | Two-Flute Design …

    • I tried to use this to drill a hole my stainless steal sink for a second faucet
    • I bougth this product to make a one inch hole in a stainless steel sink.
    • Used this to drill a hole in my stainless sink for a soap dispenser
    • I started the hole using the 1/2" bit and it took about 5 seconds to to drill through the stainless steel sink.
    • Needed to drill one hole in stainless steel sink to mount air switch for garbage disposal
    • This thing is the bees knees, not only did it perfectly drill out the whole in the stainless steel sink it also extracted some stripped screw that my screw extractor set couldn't remove
    • Worked great drilling holeinto stainless steel sink.
    • I needed to drill a 1" hold in a stainless steel sink.
    • I needed to add a hole to my stainless steel sink but the prices for these bits at the big box stores was 5 times what I paid for this one
    • I bought this to drill a hole in my stainless steel sink
    • I bought this to punch one hole large enough to install a soap dispenser in the divider of my sister in law's stainless steel sink
    • It end up warping the sink where it was catching
    • Used this for drilling a hole in a stainless steel sink and it worked great.
    • Pretty easily cut a perfect hole into the deck of a stainless steel sink
    • This worked very well to cut a 7/8" hole in a stainless steel sink for an RO filter faucet.
    • We had a stainless steel sink
    • I tried to use this to drill a hole my stainless steal sink for a second faucet
    • Needed to drill a second hole in a stainless steel sink for a soap dispenser
    • It was not good/quick at getting between sizes, and the drill bit and sink became extremely hot (sink glowing red around hole) even using cutting oil
    • I used it to enlarge a hole to 1 1/4" in a stainless steel sink not more than only 1/8" thick
    • Drilled a hole in my stainless steel sink for an air gap for the dishwasher in about 10 (fairly exciting) minutes of drilling
    • but it got the job done on a stainless steel sink for adding a soap dispenser
    • I used this to drill a hole in a stainless steel sink for washer relief valve