This made it so that it was impossible to install about half the cables on the PSU because they wouldn't clear the hard drive cage

I had a standard sized PSU (EVGA 650G 80+ Gold) and the hard drive cage went to within about half of an inch of the cable inputs for the PSU

The hard drive cages are accessible from the front and sit inside the PSU shroud

Despite being smaller, this thing would not fit in the bottom part of the case without removing the hard drive cages

It looks decent but it doesn't have much room and if you have a large or modular power supply then you'll never get to the cables because of the location of the 3.5" hard drive trays.

I had to remove the hard drive cage in order to fit the power supply

And also, you need to make sure that your PSU is not too long or the cables will be too close to the hard drive cage and push it forward

Unless you're willing to grind and mod the hard drive cage to provide more space for the PSU cables.

the stupid hard drive bracket on the rear side of the case gets in the way of being able to insert the 24 pin cable.