-
This flux improves electrical solder joints, and is much easier to use than liquid flux.
-
Dull solder joints are bad work.
-
This flux in particular helps tinning old wires and facilitates perfect joints when soldering on oxidized and/or cheap circuit boards (i.e. most consumer electronics and appliances).I'll purchase more of this when my current jar runs out.
-
This paste doesn't burn off like other flux that I've used, which makes for very clean joints with minimal effort.
-
Produces great solder joints.
-
I wets solder to make a nice solid joint, it also leaves a layer of rosin to protect the solder joints.
-
So easy and beautiful beautiful joints.
-
Helps make a secure, bright solder joint
-
Has been nice to use to reflow solder on my flight controller, to improve my solder joints
-
The Rosin helps protect the solder joint against corrosive attack, and the paste form insures that the flux stays put until soldering
-
I use 60/40 rosin core solder and the additional dab of this flux guarantees a clean, solid solder joint.
-
Remember, if your solder joint is not shiny you did a botched job
-
Without it, the joint could become cold or weaken over time, causing several issues
-
I wipe down the runoff with some acetone so it doesn't ruin the contacts or weaken joints
-
Perfect for auto & boat electronics where the joint should be protected
-
When I make a bad solder connection, a little dab of this on the end of a toothpick lets me reflow the bad joint quickly and easily
-
Really helps get a good, clean solder joint