• Reviews around bite (2.08 of 5)

    XBRN Dual Ports Adapter Splitter, 2 in 1 Headphone Jack Aux Audio & Charger Adapter Cable Connector Compactible for iP7 / 7 Plus / 8/8 Plus/X (Support Calling + Sync + Music Control + Charge)

    • At first, I was a bit apprehensive about the protection this case my give, but after a month, and around three 3 feet falls from my hands, the case has done its job protecting the phone
    • Feels a bit light and cheap but has held together well and provided a lot of protection.
    • my 6 plus does wiggle just a tiny bit in the case when you shake it
    • The only reason I didn't give five stars to the case is that it's a bit hard to clean.
    • Good, just a bit too bulky
    • I highly reccomend this case as its not a hard plastic around the it, its a bit of a soft rubber.
    • The headphone port cover does NOT fit snuggly, it always hangs out a bit no matter how hard I push on
    • While I like the new size and slimness I find it a bit hard to hold, and I have big hands
    • The case itself is a bit tricky to open in the beginning but its well worth the effort
    • Good, just a bit too bulky
    • The headphone jack is a bit difficult to fit aux cords into
    • The rear of the case could be a bit more resistant to scratches
    • The case itself is a bit tricky to open in the beginning but its well worth the effort
    • This was a bit tricky, but the bigger issue was that the installation instructions were not clear on how to detach the two pieces
    • You will notice that it's just a bit tough to reach, but not that bad - really
    • Just a bit annoying at times
    • In fairness, I went from an iphone 6+ to an iphone 6, so I'm leaning to adjust anyway, but still.. if feels like it's a bit intrusive on my typing.
    • Some may prefer it, but I still like the 5s case that has a bit more soft rubber spots that have stopped me from dropping it.
    • Priced right for the product.cons: A bit difficult to get the charger and headphones in the ports smoothly
    • It comes very close to being the perfect case-just a tiny bit more grip and a variety of colors/patterns, and it'd be even better!
    • though it is a bit hard to get the case apart at first, with a little finesse it is no problem at all.
    • Usually when you hear these type of words, you think of something that resembles an Otterbox, so when they said that this is an Ultra-thin Rugged Case, I was a bit skeptical
    • Also, the cover over the TouchID sensor makes it a bit less sensitive (some false positives) but nothing major
    • However I found that it easily traps lint and other small particles that have scratched my phone up quite a bit.
    • In fact it was a bit difficult to pull the case apart
    • In fairness, I went from an iphone 6+ to an iphone 6, so I'm leaning to adjust anyway, but still.. if feels like it's a bit intrusive on my typing.
    • We've played with it a bit and it works better now
    • n’t lose them,
    • n’t work…Pros:• I purchased the see-through