I used the alcohol cleaner to clean the areas

I removed the gorilla tape, cleaned the area, I actually put two patches on, a small square one that covered the hole, then I put part of a larger one on top of that

Make sure to follow the directions, clean the area first, and allow the the patch to set for at least 24 hours.

Due to the way the patch was rolled up, some of the patch lifted from the surface and made only certain areas usable to me

Cut to size, clean the area with the enclosed alcohol swab, apply and smooth down

I admit this was for an application along a seam which is a more difficult area and thus it was difficult to get it where it needed to go without the tape getting all twisty, but would not be a great look even if it was for an easier area

No messy glue, we just cleaned the tear area with alcohol and applied the patch

I cut away the curled areas of the patch, cleaned and again applied the product to the area and again the patch began to peel away after a couple of weeks

Followed all directions; cleaned area with enclosed alcohol wipe, waited for it to dry completely, did application during the recommended temperature range, placed patch on seat without touching sticky side with fingers, rubbed patch aggressively to aid in adhesion

I applied two overlapping patches in hope that I could get enough surface area.

The area was cleaned very well with alcohol and the patch covered the 3”x4” area well.

I admit this was for an application along a seam which is a more difficult area and thus it was difficult to get it where it needed to go without the tape getting all twisty, but would not be a great look even if it was for an easier area

After allowing it to dry for 24 hours, I used the Tear-Aid to cover, seal and protect the entire area and NO MORE LEAKS

I cleaned the area, pressed it under a light weight, and let it sit for 2 days; the patch bubbled right away and peeled right off.

Lastly, when that was dry, I cleaned the area again (with the same wipe

What comes in the box is 2 small alcohol wipes to clean the area before application and 1 piece of 3" x 12" long piece of tape.

Works exactly as it's supposed to work!

Used this to keep the plug from coming out of a not-too-well-made yoga ball

For those of you, like me, who were lost as to how to fix this at first, here's how I did it:I cut the tear-aid strip in half

Works as it should.

Works exactly as it's supposed to work!

Used this to keep the plug from coming out of a not-too-well-made yoga ball

For those of you, like me, who were lost as to how to fix this at first, here's how I did it:I cut the tear-aid strip in half

Works as it should.