-
I added dei proximity sensor, twist the blue and green wires from 2nd sensor, connect to green wire on shock sensor input that connects to the brain
-
also easy to hot wire reguardless of alarm, so put in a hidden kill switch on the starter wire that doesn't interact with the alarm
-
very disappointed, no wires, antenna or anything its useless without any of these sending it back and retrying from another company
-
Just make sure you ground the neutral safety switch wire
-
Actually hard wiring this thing into the car took about 4 hours and required removing several pieces of the dash on my wife's 06 Explorer
-
This is not something to attempt without the proper tools but you can go speed around 50 dollars at Wal- Mart and get a multi-meter and some good wire cutters and return them when you're done
-
Took about 1.5 hours to install in the hamster and a little googling found us the right wiring diagram on kia forums to wire everything super easy.
-
This indeed works fantastically well, but 16 of the some odd 53 possible wires did not need to be connected to anything
-
I had tapped onto one wrong wire for the power of the control module
-
If you know how to strip and twist wires and know how to use a multi meter, you really shouldn't have any problems.
-
By doing so, you prevent any possibility that your wires can come loose and cause a short, or an annoyance to fixHands down I give this review 5 or 5 stars
-
there is no designation of what the wires are for or support for wiring diagrams
-
At first, I ignored the second starter wire and hoped it worked fine
-
Just make sure you have a test light to check for the always hot wires and which are accessory with the ignition on