A bit hard to clean.

The only problem is cleaning the grounds, I don't know if it can be corrected, just a bit messy.

The tamping tool is now an integral bit of plastic attached to the right of the brewing handle sooooo

It is a bit difficult to get all that out, even running water through doesn’t seem to help

The machine is very light, and vibrates quite a bit during operation.

Frothing milk is a bit tricky.

It vibrates a bit while initially building pressure to make the shots and that would move my shot

The steam wand takes a bit to learn but does in fact work quite well.

During the brewing cycle, the machine vibrates quite a bit, this causes the glass to bounce around, so I typically hold it with a free hand to keep it in position

it’s a bit hard to use

The machine does shake a bit when pulling shots but again, not that big a deal for me

The position of the frother is a bit low which is also a bit odd

A bit too keep it clean

That can be a bit tricky

The first use took a bit of time, and the machine shook a bit

It does vibrate quite a bit, although I did notice that most of the time the vibrations were more than a minor nuisance it was because we had placed the metal plate into the base upside down

However, the pressure is not as strong as I

I use Lavazza Crema e gusto coffee and its wonderful! Caio ~

I bought the highly recommended Lavazza Crema e Gusto Ground Coffee Blend, Espresso Dark Roast and whoa doggie it is strong