-
The box didn’t contain the crank case vent tube connectors
-
My only mess up was tightening one of the clamps a little too much and denting the tube slightly
-
Also, regarding the intake tube, this one is actually smaller in diameter than the factory intake which is why K&N uses a reducer/adapter at the throttle body to shrink it down.
-
The couplers were nowhere the size they needed to be and the intake tube was not setup for both vent tubes from the valve covers
-
I do dislike the vent tube adapter
-
I did have an issue with either the mass air sensor seal or the crank case vent tubes not sealing.
-
Wrong intake tube for part number
-
Now the tube with this is metal as oppose to plastic with the Airaid, but this CAI came with plastic fittings that had to be screwed in to the tube.
-
n’t want an exhaust but just a meaner sound when I get on the throttle
-
n’t have exhaust and after installing this