To my surprise, same problem occurred but with the top plate on both stand

After a year or so, the top plate has become very very loose, causing the speakers to wobble if someone walks by

After a year or so, the top plate has become very very loose, causing the speakers to wobble if someone walks by

The backing plates that hide the speaker wires is a little finicky...but over all decent

My 10 gauge wire did fit thru the bottom then top plate holes with welded in place banana jacks

The instructions are no good - for example, put the metal pins in the top plate BEFORE you screw it onto the support.

The dimensions of the top plate shown on the Second Image are not completely correct.

Also to hole to pass the wires through on the top plate is too small (may 1/4" dia) but you really need a 1/2" hole to pass 12 gauge wires

After both plastic cover being done, start to screw the bottom plate and the top plate to the pillar.

The screw that holds the top plate in place has somehow stripped, please note that they were only screwed in once during assembly, and not wrenched down

The screws holding the top plates didn’t tighten as well as I would have liked, so I used some longer screws which